Aluminium Gutters Direct

Alumasc Cast Iron Deep Half Round Guttering

Shop by
manufacturer

Official supplier
4.9 across Google & Trustpilot BBA-certified powder coatings Manufacturer warranties on every range
Not sure which? Call the technical desk 0330 0539354
Alumasc
From £93.94 £261.61
-64%
In stock
Alumasc
From £64.50 £179.62
-64%
In stock
Alumasc
From £64.50 £179.62
-64%
In stock
Alumasc
From £64.50 £179.62
-64%
In stock
Alumasc
£64.50 £179.62
-64%
In stock
Alumasc
£64.50 £179.62
-64%
In stock
Alumasc
From £21.59 £60.11
-64%
In stock
Alumasc
From £21.59 £60.11
-64%
In stock
Alumasc
From £21.59 £60.11
-64%
In stock
Alumasc
From £18.43 £51.32
-64%
In stock
Alumasc Apex Heritage - 5"x3" Deepflow Galvanised Steel Rise & Fall Bracket WS - Aluminium Gutters Direct
Alumasc
£14.47 £40.28
-64%
In stock
Alumasc Apex Heritage - 5"x3" Deepflow Galvanised Steel Side Fix Rafter Brackets - Aluminium Gutters Direct
Alumasc
£12.19 £33.95
-64%
In stock
Alumasc Apex Heritage - 5"x3" Deepflow Galvanised Steel Top Fix Rafter Brackets - Aluminium Gutters Direct
Alumasc
£11.29 £31.45
-64%
In stock

ALUMASC CAST IRON DEEP HALF ROUND GUTTERING · COMMON QUESTIONS

Something not answered here? The technical desk takes calls on 0330 0539354
What problem does Deep Half Round solve?
It increases capacity for steep pitches and high rainfall zones without moving to a box profile, reducing overflow risk at eaves.
Any installation differences vs standard half round?
Bracket centres remain similar but expect slightly heavier runs. Double-bracket near outlets and angle pieces to control deflection under load.
What sealants are preferred on deeper sections?
Use low-modulus neutral cure silicone approved for cast iron and ensure even compression at the joint bolts to avoid capillary draw.
What standards and finishes do Alumasc cast iron rainwater products comply with?
All Alumasc Apex Heritage cast iron gutters, downpipes and fittings are manufactured to BS 460:2002 for cast iron rainwater goods and supplied either factory primed or with a high-performance two-pack painted finish. Factory finishes are certified for long-term protection and colour consistency.
What are the typical lengths, bracket centres and falls for installation?
Most gutters and downpipes are supplied in 1.83 m (6 ft) lengths. Gutters are typically bracketed at 915 mm centres with extra brackets either side of joints, outlets and angles, and set to a fall of roughly 1:600 to 1:350.
How are joints made and sealed on site?
Traditional spigot-into-socket joints are made using a low-modulus silicone or rubberised bitumen mastic, then bolted through the pre-drilled joint holes using corrosion-resistant bolts and washers.
What about durability, repainting and lifecycle?
Cast iron is extremely strong, vandal-resistant and dimensionally stable. Life expectancy is typically 40+ years with correct installation and periodic maintenance. Factory-painted finishes minimise site time; primed goods can be site painted to the required scheme.
Are Alumasc cast iron systems suitable for heritage and sustainable projects?
Yes. They are widely used on listed and conservation properties because they replicate traditional profiles and details, and cast iron is 100% recyclable at end of life.