Alumasc Cast Iron Victorian Ogee Guttering

In late-19th-century and Edwardian stock where the sharper ogee suits brick detailing and heavy cornices.

Keep the heavier front lip supported. Double-bracket near angles and outlets to control deflection under snow or wind load.

Factory two-pack keeps sharp arrises and reduces site time. Primed supply is an option where heritage topcoats are mandated.

All Alumasc Apex Heritage cast iron gutters, downpipes and fittings are manufactured to BS 460:2002 for cast iron rainwater goods and supplied either factory primed or with a high-performance two-pack painted finish. Factory finishes are certified for long-term protection and colour consistency.

Most gutters and downpipes are supplied in 1.83 m (6 ft) lengths. Gutters are typically bracketed at 915 mm centres with extra brackets either side of joints, outlets and angles, and set to a fall of roughly 1:600 to 1:350.

Traditional spigot-into-socket joints are made using a low-modulus silicone or rubberised bitumen mastic, then bolted through the pre-drilled joint holes using corrosion-resistant bolts and washers.

Cast iron is extremely strong, vandal-resistant and dimensionally stable. Life expectancy is typically 40+ years with correct installation and periodic maintenance. Factory-painted finishes minimise site time; primed goods can be site painted to the required scheme.

Yes. They are widely used on listed and conservation properties because they replicate traditional profiles and details, and cast iron is 100% recyclable at end of life.